 |  | 
Description & Features:
Wave-Table Synthesis
- Creative synthesis engine
- Digital effects engine for reverb and chorus
- 128-voice polyphony and multi-timbral capability
- 16 MIDI channels, 128 GM & GS compatible instruments and 10 drum kits
- MT-32 compatible instrument set
3D Audio Technology
- Support for Microsoft® DirectSound® and DirectSound 3D™ and derivatives audio technology.
- User selectable algorithms for two or four speaker modes
- Multi-algorithm reverb and chorus
Memory Subsystem
- Utilizes system RAM for wave-table synthesis
- User configurable for 2MB, 4MB or 8MB
CD-Quality, 16-Bit Stereo Digital Audio
- 8- and 16-bit, mono and stereo recording and playback
- User-selectable sample rates from 5kHz to 48kHz
- Powerful amplifier for driving headphones or passive speakers
- Full-duplex support enables simultaneous record and playback for Internet communications software
MIDI Interface / Joystick Port
- Built-in 15-pin MIDI interface (requireds MIDI adapter, available separately)
- Works with Sound Blaster® and MPU-401 UART modes
- IBM®-compatible 15-pin joystick port with analog and digital support
On-Board Connectors
- Microphone in
- MPC-3 CD Audio in
- Line Level out
- Amplified out
- Auxiliary In / Rear Out
- MIDI / Joystick port
Works with the Following Standards
- Windows® 95
- Windows 98
- Windows NT 4.0
- General MIDI
- MPC-3
- Plug-and-Play
- Microsoft DirectSound, DirectSound 3D, and derivatives
|
Specifications:
| Frequency Response: |
30Hz - 20KHz (Line-out) |
| Signal to Noise Ratio: |
90 db |
| Total Harmonic Distortion @ 1 Vrms (10 KOhm load): |
0.01% |
| Sampling Rate for Playback/Recording (Stereo): |
4 KHz - 48 KHz |
| Supply Voltage Requirement (Loading): |
+5, +12, -12 Volt |
| Current Consumption (Typical): |
250, 500, 50 mA respectively |
| Microphone Impedance: |
600 Ohms |
| Line-In Impedance: |
47 KOhms |
| CD Audio-In Impedance: |
50 KOhms |
| Microphone Sensitivity: |
10 - 200 mVpp |
| Line-In Sensitivity: |
0 - 2 Vpp |
| CD Audio-In Sensitivity: |
0 - 2 Vpp |
| AD/DA Resolution: |
16 bits |
| Environment Temperature (non-operating): |
-40C to 70C |
| Environment Temperature (operating): |
10C to 50C |
| Relative Humidity (non-operating): |
30% to 95% |
| Relative Humidity (operating): |
30% to 80% |
| MTBF: |
>60,000 hours |
| Drop Test: |
30cm above concrete ground on all 6 sides |
| Vibration: |
Sine wave for X, Y and Z axis (non-operating) |
| 5Hz to 15Hz : |
0.76mm (P-P) |
| 15Hz to 25Hz : |
1.5G |
| 25Hz to 50Hz : |
0.15mm (P-P) |
| 50Hz to 100Hz : |
3G |
| Information subject to change without notice |
Line-In (it is also Rear-Out, software selectable)
Microphone-In
Line-Out (Front)
MIDI/Joystick Port
CD-ROM Audio-In
Internal TAD Connector
Internal TV Tuner Connector |
| Minimum System Requirement |
Genuine Intel® Pentium® class 133MHz or faster processor
Intel® or 100% compatible motherboard chipset
16MB system RAM (32MB strongly recommended)
Windows® 95, Windows® 98 or Windows NT® 4.0*
Open half-length PCI 2.1 compliant slot
Headphones or amplified speakers (available separately)
CD-ROM drive required for software installation |
Product Content:
- Creative Labs CT4750 - Sound Blaster SB128PCI Sound Card (CT4751)
- - SOFTWARE NOT INCLUDED -
Before you purchase this item, please ensure that you have verified compatibility with system by visiting the manufacturer's web site.
We assume no responsibility and will not accept full refunds for items purchased that are not compatible with your system configuration.
|
Conditions:
Warranty:
| |
|
